Home » Compliance Management Blog- ESG, EHS, EHSQ » New Plastics Pipes Standards for the 1st Quarter 2016

New Plastics Pipes Standards for the 1st Quarter 2016

Kyle Bach

Document Center, Inc. is pleased to announce that the following Standards on Plastics Pipes are now available;


  • ASTM D1598, 2015A Edition, Standard Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure
  • ASTM D2852, 2016 Edition, Standard Specification for Styrene-Rubber (SR) Plastic Drain Pipe and Fittings
  • ASTM F449, 2016 Edition, Standard Practice for Subsurface Installation of Corrugated Polyethylene Pipe for Agricultural Drainage or Water Table Control
  • ASTM F667, 2016 Edition, Standard Specification for 3 through 24 in. Corrugated Polyethylene Pipe and Fittings
  • ASTM-F1055, 2015 Edition, Standard Specification for Electrofusion Type Polyethylene Fittings for Outside Diameter Controlled Polyethylene and Crosslinked Polyethylene (PEX) Pipe and Tubing
  • ASTM F1412, 2016 Edition, Standard Specification for Polyolefin Pipe and Fittings for Corrosive Waste Drainage Systems
  • ASTM F2023, 2015 Edition, Standard Test Method for Evaluating the Oxidative Resistance of Crosslinked Polyethylene (PEX) Pipe, Tubing and Systems to Hot Chlorinated Water
  • BS EN ISO 9967, 2016 Edition, Thermoplastics pipes. Determination of creep ratio
  • BS EN ISO 9969, 2016 Edition, Thermoplastics pipes. Determination of ring stiffness
  • BS ISO 21307, Corrigendum 1 for the 2011 Edition, Plastics pipes and fittings. Butt fusion jointing procedures for polyethylene (PE) pipes and fittings used in the construction of gas and water distribution systems
  • BS ISO 8513, 2016 Edition, Plastics piping systems. Glass-reinforced thermosetting plastics (GRP) pipes. Test methods for the determination of the initial longitudinal tensile strength
  • ISO 8513, 3rd Edition, Plastics piping systems – Glass-reinforced thermosetting plastics (GRP) pipes – Test methods for the determination of the initial longitudinal tensile strength
  • ISO 9967, 3rd Edition, Thermoplastics pipes – Determination of creep ratio
  • ISO 9969, 3rd Edition, Thermoplastics pipes – Determination of ring stiffness


For more standards like these, please refer to our Document Center List of Standards on Plastics Pipes.