Home » Compliance Management Blog- ESG, EHS, EHSQ » New Plastic Pipe Standards for the 2nd Quarter 2014

New Plastic Pipe Standards for the 2nd Quarter 2014

Kyle Bach

Document Center Inc. is pleased to announce that the following New Standards on Plastic Pipes are now available:


  • ASTM D2513, 2014 Edition with Editorial Correction, Standard Specification for Polyethylene (PE) Gas Pressure Pipe, Tubing, and Fittings
  • ASTM D2665,  2014 Edition, Standard Specification for Poly(Vinyl Chloride) (PVC) Plastic Drain, Waste, and Vent Pipe and Fittings
  • ASTM D3296, 2014 Edition, Standard Specification for FEP-Fluorocarbon Tube
  • ASTM D3681, 2012 Edition with Editorial Correction, Standard Test Method for Chemical Resistance of ‘Fiberglass’ (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe in a Deflected Condition
  • ASTM D3839, 2014 Edition, Standard Guide for Underground Installation of ‘Fiberglass’ (Glass-Fiber Reinforced Thermosetting-Resin) Pipe
  • ASTM F1504, 2014 Edition, Standard Specification for Folded Poly(Vinyl Chloride) (PVC) Pipe for Existing Sewer and Conduit Rehabilitation
  • BS ISO 4427-2, 2007 Edition with Amendment A1, Plastics piping systems. Polyethylene (PE) pipes and fittings for water supply. Pipes
  • BS ISO 8513, 2014 Edition, Plastics piping systems. Glass-reinforced thermosetting plastics (GRP) pipes. Test methods for the determination of the apparent initial longitudinal tensile strength
  • BS ISO 10952, 2014 Edition, Plastics piping systems. Glass-reinforced thermosetting plastics (GRP) pipes and fittings. Determination of the resistance to chemical attack for the inside of a section in a deflected condition
  • BS ISO 17484-1, 2014 Edition, Plastics piping systems. Multilayer pipe systems for indoor gas installations with a maximum operating pressure up to and including 5 bar (500 kPa). Specifications for systems
  • ISO 4427-2 Amendment 1, Amendment 1 for 1st Edition, Polyethylene (PE) pipes and fittings for water supply – Part 2: Pipes, Plastics piping systems
  • ISO 8513, 2nd Edition, Plastics piping systems – Glass-reinforced thermosetting plastics (GRP) pipes – Test methods for the determination of the apparent initial longitudinal tensile strength
  • ISO 8779 Amendment 1, Amendment 1 for 3rd Edition, Plastics piping systems — Polyethylene (PE) pipes for irrigation — Specifications
  • ISO 10952, 3rd Edition, Plastics piping systems – Glass-reinforced thermosetting plastics (GRP) pipes and fittings – Determination of the resistance to chemical attack for the inside of a section in a deflected condition


For more standards like these, see our Document Center List of Standards on Plastic Pipes.

And you’ll also want to take a look at my previous blog: